+- Madison Motorsports (https://forum.mmsports.org)
+-- Forum: Madison Motorsports (https://forum.mmsports.org/forumdisplay.php?fid=3)
+--- Forum: Lounge (https://forum.mmsports.org/forumdisplay.php?fid=6)
+--- Thread: 37/64 Drill bit...HALP! (/showthread.php?tid=8924)
37/64 Drill bit...HALP! - Jeff - 06-21-2010
Anyone have a 37/64 drill bit I could borrow? I will pay postage both ways obviously. Needed ASAP, thanks!
Re: 37/64 Drill bit...HALP! - Ryan T - 06-21-2010
Go to the hardware store and pay the $11 it'll cost to buy one?
Re: 37/64 Drill bit...HALP! - CaptainHenreh - 06-21-2010
Ryan T Wrote:Go to the hardware store and pay the $11 it'll cost to buy one?
Seriously, I'm sure you can get it from Solenbergers.
Re: 37/64 Drill bit...HALP! - Jeff - 06-21-2010
None to he had here. NAPA is $25. Haven't checked Lowe's yet.
Re: 37/64 Drill bit...HALP! - Apoc - 06-21-2010
If you're willing to wait on the mail, just order it from amazon.
Re: 37/64 Drill bit...HALP! - Mike - 06-21-2010
Apoc Wrote:If you're willing to wait on the mail, just order it from amazon.
and i'm willing to order it for you since i have prime... $4 overnight or free 2-day.
Re: 37/64 Drill bit...HALP! - Apoc - 06-21-2010
Maybe Prime can just blast a hole that's 37/64?
![[Image: optimus_prime.jpg]](http://scottthong.files.wordpress.com/2006/08/optimus_prime.jpg)
Re: 37/64 Drill bit...HALP! - Mike - 06-21-2010
are you high?
Re: 37/64 Drill bit...HALP! - Apoc - 06-21-2010
Mike Wrote:are you high?
I think so.
Re: 37/64 Drill bit...HALP! - Jeff - 06-22-2010
Thanks Mike. I actually ended up doing the job without the bit. It wouldn't fit up in there if I would have had it. Luckily the hole was large enough that the tap just cut through.